PL SERIES DIGITAL POWER AMPLIFIERS Order ref: 172.232UK, 172.
Caution: Please read this manual carefully before operating Damage caused by misuse is not covered by the warranty Features Class H, 2-step architecture Compact and light weight High efficiency, high output Independent dual-level clip limiters Independent dual-level high-pass filters Stereo, Parallel or Bridge Mono modes Fully balanced signal path Dual fan cooling Soft-start on power up Multi-level system protection Introduction: Thank you for choosing this Citronic Powerlite amplifier
Front Panel 10. 11. 12. 13. PM Parallel Mode indicator BM Bridge Mono mode indicator CLIP indicators OUTPUT indicators 5. 6. 7. 8. SIGNAL indicators CH1 and CH2 level controls Cooling vent POWER switch 15. 16. 17. 18. 19. 20. CLIP LIMITER switch GAIN input level selector MODE switch (Parallel/Stereo/Bridge) CH1 and CH2 High Pass Filters (HPF) GROUND LIFT switch Signal line outputs (XLR) Rear Panel 9. 10. 11. 12. 13. 14.
STEREO is the normal mode of operation where each input is delivered to each output independently BRIDGE mode couples both amplifier sections together to deliver the full rated power to a single output. The minimum impedance is 8Ω in this mode. An LED (“BM”) shows when this mode is engaged The GROUND LIFT switch disconnects signal ground (or “earth”) from mains ground. In certain cases, it may help to alleviate mains hum – otherwise, leave ground connected to mains ground.
