User Manual
16
Note:
If you use the NVR with the PoE network ports, the online state of the internal ethernet port
will be shown on the interface. Refer to the picture below. Please refer to 11.1.1 TCP/IPv4
Configuration for detail introduction of the internal ethernet port.
④ QRCode. You can scan the QRCode through mobile client which is installed in the mobile
phone or PAD to log in the mobile client instantly. Please refer to 12.1 Mobile Client
Surveillance for details.
⑤ Add Camera. Click “Refresh” to refresh the list of online IP cameras which are in the
same local network with NVR and then click to add the searched camera. Click “Add
All” to add all the cameras in the list. Click to delete the added camera. Click “Delete
All” to delete all the added cameras.