User Manual

32
 Add Scheme
Click in area ① to create a new scheme. Click on the top right corner of the
scheme to delete it.
 Configure Scheme
a) Select a scheme in area ① and then click the screen mode button on the tool bar to set the
screen mode of the scheme.
b) Select a camera window in area ② and then double click the camera or group in area ③.
The camera or group will be added into the selected window. One camera in the same scheme
cannot repeat. You can click the right-click menu “Clear” in area ② to remove a single camera
or click to remove all the cameras.
c) Click “Apply” to save the settings.
 Start Sequence View
Go to live preview interface and then click to pop up a window. Set the dwell time in the
window and then click to start scheme view in sequence. Double click the sequence view
interface to pause the view; double click again to restore the view. Click to stop the view.
5.3 Preview Image Configuration
5.3.1 OSD Settings
Click StartSettingsCameraImageOSD Settings to go to the interface as shown below.
Select the camera, input the camera name (or double click the camera name in the camera list
to change the camera name), enable or disable the name and time OSDs (if enabled, drag the
red name and time OSDs directly in the image view area to change the OSDs’ display position)
and select the date and time formats. Click “Apply” to save the settings.