User Manual

33
5.3.2 Image Settings
Click StartSettingsCameraImageImage Settings to go to the following interface.
Select the camera and then set the brightness, contrast, saturation and hue of the camera. You
can click “Default” button to restore the image settings to the default factory settings.
5.3.3 Mask Settings
Some areas of the image can be masked for privacy. Up to four mask areas can be set for each
camera. Click StartSettingsCameraImageMask Settings to go to the interface as
shown below. Select the camera and enable the mask. Click “Draw” button and then drag the
mouse on the image area to set the mask area; click “Delete” button to delete the mask areas;
click “Apply” to save the settings.