User Manual

7.4.2 Timing Recording

Timing Recording: the system will record automatically according to the schedule.

Set the timing record schedule of each camera. See 7.3 Schedule Setting for details.

7.4.3 Motion Based Recording

Motion Based Recording: the system will start motion based recording when the motion

object appears in the setup schedule. The setup steps are as follows:

① Set the motion based recording schedule of each camera. See 7.3 Schedule Setting for

details.

② Enable the motion and set the motion area of each camera. See 9.2.1 Motion

Configuration for details.

The camera will start motion based recording once you finish the above settings.

7.4.4 Sensor Based Recording

① Set the sensor based recording schedule of each camera. See 7.3 Schedule Setting for

details.

② Set the NO/NC type of the sensor, enable the sensor alarm and then check and configure

the “Record”. See 9.1 Sensor Alarm for details.

7.5 Disk Management

Click StartSettingsDiskDisk Management to go to disk management interface. You can

view the NVR’s disk number and disk status and so on in the interface. Click “Formatting”

button to format the HDD.

7.5.1 Storage Mode Configuration

Click StartSettingsDiskStorage Mode to go to the interface as shown below.

Note: 1. The new HDD should be formatted for normal use.

2. For normal use of the HDD which has been used in other NVR, if the NVR is of the same

model with the new NVR, please import the configuration file of the NVR to the new NVR or

format the HDD; if the models of the two NVRs are different, please format the HDD.