User Manual

9 Alarm Management

9.1 Sensor Alarm

To complete the entire sensor alarm settings, you should enable the sensor alarm of each

camera and then set up the alarm handling of each camera.

① Click StartSettingsAlarmSensor Alarm to go to the following interface.

② Select the alarm type (NO or NC) according to trigger type of the sensor.

③ Enable the sensor alarm of each camera.

④ Check the “Record”, “Snap”, “Alarm-out” and “Preset” and enable or disable the

“Buzzer”, “Pop-up Video”, “Pop-up Message Box” and “E-mail” as required.

⑤ Click “Apply” to save the settings.

The configuration steps of the above mentioned alarm linkages are as follows.

Record: check it and then the “Trigger Record” window will pop up automatically (you can

also click “Configure” button to pop up the window). Select camera on the left side and then

click to set the camera as the trigger camera. Select trigger camera on the right side and

then click to cancel the trigger camera. Click “OK” button to save the settings. The

trigger cameras will record automatically when the sensor alarm is triggered.

Snap: check it and then the “Trigger Snapshot” window will pop up automatically. Configure

the trigger camera in the window. The trigger cameras will snap automatically when the sensor

alarm is triggered.

Alarm-out: check it and then the “Trigger Alarm-out” window will pop up automatically.

Configure the trigger alarm-out in the window. The system will trigger the alarm-out

automatically when the sensor alarm is triggered. You need to set the delay time and the

schedule of the alarm outputs. See 9.4.1 Alarm-out for details.

Preset: check it and then the “Trigger Preset” window will pop up automatically. Configure the

trigger preset of each camera. To add presets, please see 6.2 Preset Setting for details.

Buzzer: if enabled, the system will begin to buzz when the sensor alarm is triggered. To set the

delay time of the buzzer, please see 9.4.4 Buzzer for details.

Pop-up Video: After camera setting, the system will pop up the corresponding video

automatically when the sensor alarm is triggered. To set the duration time of the video, please

see 9.4.3 Display for details.