User Manual

③ Drag the camera image to set the motion area. You can set more than one motion area.

Click “All” to set the whole camera image as the motion area. Click “Reverse” to swap the

motion area and the non-motion area. Click “Clear” to clear all the motion areas.

④ Click “Apply” to save the settings. Click “Processing Mode” to go to the alarm handling

configuration interface of the motion alarm.

9.2.2 Motion Alarm Handling Configuration

① Click StartSettingsAlarmMotion Alarm to go to the following interface.

② Enable or disable “Snap”, “Alarm-out”, “Preset”, “Buzzer”, “Pop-up Video” and “E-mail”.

The alarm handling setting of motion alarm is similar to that of the sensor alarm (see 9.1

Sensor Alarm for details).

③ Click “Apply” to save the settings. You can click “Motion Settings” to go to the motion

configuration interface.

9.3 Exception Alarm

9.3.1 Exception Handling Settings

① Click StartSettingsAlarmExceptionException Handling Settings to go to the

interface as shown below.

② Enable or disable “Alarm-out”, “Buzzer”, “Pop-up Message Box” and “E-mail”. The

exception handling settings are similar to that of the sensor alarm (see 9.1 Sensor Alarm for

details).

③ Click “Apply” to save the settings.