User Manual
74
11 Device Management
11.1 Network Configuration
11.1.1 TCP/IPv4 Configuration
IP Address Settings
Click StartSettingsNetworkTCP/IPv4 to go to the following interface. Check “Obtain an
IP address automatically” and “Obtain DNS automatically” to get the IP address and DNS
automatically, or manually input IP address, subnet mask, gateway, preferred DNS and
alternate DNS. Click “Apply” to save the settings.
Internal Ethernet Port Introduction:
If you use the NVR with the PoE network ports, the online state of the internal ethernet port
will be shown on the interface. Refer to the picture below.
The internal ethernet port is the port which connects all the PoE ports with the NVR system.
The PoE ports are available if the internal ethernet port is online; if it is offline, all the PoE
ports will be unavailable, may be the internal ethernet port is broken. The IP address and subnet
mask of the internal ethernet port can be changed to make the port in the same network