User Manual

75
segment with the IP cameras which directly connect to the PoE ports of the NVR (it is not
recommended to change the IP address and subnet mask of the internal ethernet port).
 PPPoE Settings
In the above interface, check “Enable” in “PPPoE Settings” and then input the username and
password obtained from the dealer. Click “Apply” to save the settings.
11.1.2 Port Configuration
Click StartSettingsNetworkPort to go to the interface as shown below. Input the HTTP
port, server port and RTSP port of the NVR and then click “Apply” to save the ports.
HTTP Port: the default HTTP port of the NVR is 80. The port number can be changed to
others like 81. The port is mainly used to IE remote access. If you want to access the NVR