User Manual

12 Remote Surveillance

12.1 Mobile Client Surveillance

① Enable NAT in the NVR. Refer to 11.1.6 NAT Configuration for details.

② Download and install the mobile client “SuperLive Plus” into the mobile device with the

Android or iOS system.

③ Run the mobile client, go to the “Add Device” interface and then click to scan the

QRCode of the NVR (Go to StartSettingsSystemInformationBasic to view the

QRCode of the NVR).

④ After scanning the QRCode successfully, input the login password to log in mobile client.

12.2 Web LAN Access

① Click StartSettingsNetworkTCP/IPv4 to go to the “TCP/IPv4” interface. Set the IP

address, subnet mask, gateway, preferred DNS and alternate DNS of the NVR.

② Open IE browser on a computer, input the IP address of the NVR in the IE address bar and

then press enter to go to the login interface as shown below. You can change the display

language on the top right corner of the login interface. Input the username and password of the

NVR in the interface and then click “Login” to go to the live preview interface.