User manual

BROWSING THE MENU TREE ENG
Page 33
To browse the menu:
- The Enter button (or pressing the shuttle knob) has a dual function: to allow access to a menu sublevel, and to save
a new parameter or function value.
- The Esc button (or selecting ‘Quit’ and then pressing Enter) allows you to exit a menu sublevel or parameter editing
screen (exit without saving
)
- Every time you access a parameter or function, the display shows its current value or status. Alternative
to current
values or states may be seen by turning the shuttle. Keep in mind that simply displaying a new value (even when
flashing) loads this value (temporarily) into the processor memory, and thus implements it immediately. This
therefore allows the operator to obtain real-time feedback
on the changes made.
Once you have highlighted the new value, you may confirm (save) or cancel it.
- Press Enter a first time to enter the Save function, and then again to confirm
- Press Esc to quit the menu without saving and return to the next higher menu layer.
Then press Esc repeatedly (or wait a few moments) to return to the default screen (menu root).
NOTE – Contrary to the submenu parameters, a new curve becomes operative (thus is broadcast) only when it is
selected
via encoder and then confirmed by the ENTER command within 10 seconds after selection.
Instead of front panel access, you may also access all processor functions and operating parameters using the
specific PC control software provided with the equipment (see chapter 28).
We recommend using this software, since it allows immediate monitoring and makes it easier to set the curves,
levels and functions of the processor, even from a remote location.
REMARKS
the menu item are all displayed, even if the corresponding hardware or software option is not installed
If the processor does not feature the RDS option, the message «RDS Demo Signal» will appear at the
top of the display