User manual

I/O CALIBRATION AND SYSTEM SETUP ENG
Page 37
20 I/O CALIBRATION AND SYSTEM SETUP
The processor is designed for easy installation and set up. All necessary interface connections are made through rear
panel connectors. Refer to Rear Panel Connectors Chapter for a description and placement of each of the connections.
With proper installation and calibration the processor will give you the most accurate results for audio
processing and modulation. Take the time to go through the steps provided in this chapter to ensure you get the
most out of your equipment.
Power on the unit: the main (default) screen:
will appear in the window display.
Before starting, make sure the unit is running all the default parameters values, as set in the factory at
the delivery time. See the final pages for the list of default settings for reference.
20.1 ANALOG / DIGITAL AUDIO INPUT SELECTION
Skip this step if you do not have the optional DG-IN module installed or if you are not using the digital audio input.
Firstly, You have to chose whether You will use the analog input or the digital audio input
The unit is shipped from the factory with the ANALOG input activated. With e DG-IN option installed, You may enable the
digital audio input by entering the DGINP MODULE menu and switching the Digital Input ON:
DEFAULT SCREEN
OPTIONAL CONTROLS menu
DIGINP MODULE page
Digital Input ON
Remarks:
- Connect only one type of signal at a time (coaxial or optic) to avoid malfunctions.
- The Digital Input LED on the front panel GLOWS when the digital input is active.
- Enabling digital input simultaneously cuts out analog input.
- The digital input audio level may not
be adjusted.