User manual

SETUP OF MPX OUTPUT (FM version only) ENG
Page 51
25.4 RDS SIGNAL LEVEL CONTROL (FM VERSION ONLY) ***
The processor generated RDS signal level and phase can be adjusted by means of the RDS Module menu.
DEFAULT SCREEN
OPTIONAL CONTROLS menu
RDS MODULE menu
RDS LEVEL (or RDS PHASE)
The RDS signal Level may be adjusted within the deviation range of 1.0 to 6.0 kHz (default operating level: -31.5dB,
D=2.0 KHz). The relation between deviation and level is as in the following table:
-37.5 dB D=1.0 KHz
-31.5 dB D=2.0 KHz
-28 dB D=3.0 KHz
-25.5 dB D=4.0 KHz
-23.5 dB D=5.0 KHz
-21.9 dB D=6.0 KHz
- The RDS function may be disabled
by turning the shuttle counter-clockwise to Off.
- The RDS signal is available on the MPX Out connector, mixed together with the MPX signal. Also see par. 25.1 for
setting the overall MPX signal.
Message content, times and Alternative Frequencies lists may be programmed solely by means of a PC,
with the control software installed. See chapter 28.
When the RDS option is not installed, the RDS Module menu still allows you to broadcast a demo
version (RDS Demo), which supports all the services of the full version but which is not user-
programmable. The RDS option can be installed also after purchasing the equipment To do so, notify
the manufacturer of your firmware code (see par. 26.3)