User manual

THE PC CONTROL SOFTWARE (FM , ST/WEB, TV versions) ENG
Page 59
28.3 MONO-DIRECTIONAL MODE (REMOTE)
The picture shows the mono directional connection mode,
which does not involve any return channel. It is possible to
send commands to the equipment from remote sites, but
does not allow either remote monitoring of the machine, nor
confirmation of control reception.
The typical application is centralized control – via satellite
–
of equipment installed at different transmitting sites.
To enable MONODIRECTIONAL processor control, You
need to assign a specific name to every piece of equipment
(Target name) and to assemble them into groups (Group
name, i.e. corresponding to a region), so as to enable
selective programming