User manual

THE PC CONTROL SOFTWARE (FM , ST/WEB, TV versions) ENG
Page 60
28.4 INSTALLATION
A) Using standard Windows procedures, access the PC REMOTE SOFTWARE folder and run the SETUP.EXE file
under the Microsoft Windows® ’95, ’98, ME, 2000, NT and XP operating system.
B) The install program installs Pc remote Control application onto the computer's hard disk. The installation screen will
also suggest a destination directory for the software. If You have a reason to specify another directory for installation, use
the Browse button or type an alternative path.
C) Click to Install and Next to complete installation. This takes only a few seconds. When the software is successfully
installed, Finish message will appear at the bottom of the installing box. Click Close to close the installation screen.
D) Standard Windows procedures can be used to create a shortcut to the program on the desktop.
it is advised to completely uninstall possible existing older versions before running the new one.
To uninstall the exisiting Pc control software, proceed as follows:
- enter the Windows «Control Panel»
- click on the « Install Applications » icon
- choose the item of current version from the list and select it
- click on the «Add/Remove» button
- confirm deletion of all proposed files
- run the new Remote Control program starting from the 'Programs' Menu of the Start button on Yr Pc
There is a direct correspondence between the firmware and software versions.
For example, the rel. 3.0 of Pc software requires the firmware version 3.0 installed on the processor and
viceversa.
More precisely, the two first digits must match, as possible sub-releases (identified by the third digit) are
not involved in the firmware/software compatibility.
As general rule, software version X.Y.Z runs with firmware version X.Y.K