User manual

THE PC CONTROL SOFTWARE (FM , ST/WEB, TV versions) ENG
Page 67
The submenus available are the same ones available with the bidirectional connection, thus:
- The three buttons located alongside the display allow you to edit the new broadcast processing curve: select the
curve from among the 40 available, using the two arrows, then confirm the choice using the rectangular button in the
middle.
The Edit submenu contains all of the parameters and operations regarding setting a new processing curve. Note that
in this case it is NOT possible to use the Get Preset function to call up one of the existing curves, but simply to set
the various parameters of a new curve (compressor threshold levels, Density and Brilliance levels, level and type of
Super bass). Once this curve has been set, it must be saved in one of the 10 locations set aside for the user
(through the ‘Save As’ window at the lower left of the Edit screen), then the command sent to the processor (‘Save’
button in the lower right): the processor will automatically start using the new curve.
- The Output submenu includes the controls for the functions: Output Level, Pre-emphasis, Noise Gate, Output Mode.
- The Input submenu includes the controls for the functions: AGC Mode, AGC Speed and AGC Level
- The MPX submenu includes the controls for the functions: Pilot Phase and Pilot Level
- The PlugIn submenu includes the controls for the optional functions available: RDS Level and Phase, Stereo
Enhancer Effect Level – Effect Band and Effect Depth, Digital Input On or Off.
- The RDS submenu includes the programming windows for the RDS functions
NOTE: In each menu, any changes to the parameters may be saved by clicking the ‘Send’ button, while clicking ‘Cancel’
allows you to abandon the changes (or the submenu) without saving.
Note that, while receiving a relevant data packet, the processor display momentarily shows the message Remote PC
Host in Control.