User manual

Using the RDS SECTION (FM version ONLY) ENG
Page 68
29 USING THE RDS SECTION (FM version ONLY)
The processor includes, as an option, a complete RDS encoder, programmable by a PC connected to its Serial Port 1
(bidirectional) or Serial 2 (monodirectional). This allows you to install encoders throughout the network, including local
stations, and set them using a ‘master’ PC.
The RDS upgrade procedure, if the RDS plug-in is not already present in your processor, is explained in one of the next
chapters.
The RDS section controls (for RDS messages and other services) are accessible only via the remote control software
supplied with your processor. Please refer to the previous chapter for installation & setup procedure instructions for this
software.
29.1 MAIN SCREEN
Once the program has been launched, access the RDS section by clicking the ‘MAIN’ button on the right: This will open
the main screen, where you can set the main parameters of the RDS service.
Once you have finished loading one or more fields, click Send to enable one or more parameter
changes or click Cancel to quit without save the changes.