User manual

FIRMWARE UPGRADE PROCEDURE ENG
Page 80
D) Copy (or move) the RDS key (unzipped
) into that Firmware_Upgrade folder
E) Run the file DAP_Vxy_STD_RDS: the Upgrader will automatically check the presence of the enabling
‘key’ in the same folder
F) Follow points I) throughout N) described at Paragraph 2)
With RDS option NOT installed, the processor will display the message ‘RDS DEMO SIGNAL’ when
accessing the Optional Controls/RDS Module/RDS Level menu.
With the RDS option correctly installed, the processor will display the message ‘RDS SIGNAL’ when
accessing the Optional Controls/RDS Module/RDS Level menu.
IN CASE OF FIRMWARE VERSIONS FORMER TO 2.0 (FM version only)
In case of firmware versions former to 2.0, it is necessary to install a 10 KΩ resistor, ¼ Watt, 5% on the processor
mother board before upgrading the firmware.
Please proceed as follows:
• shut off the processor and unplug the power cord.
• remove the equipment cover and the guarantee labels
• install a 10 KΩ resistor, ¼ Watt, 5 % (type SMD or traditional) rows 20A and 20B next to the front panel connector
(IperDasp board – see Figure).
Once you have inserted the resistor, continue with the firmware upgrade as described above.