User manual

MANO870 Mini ITX Board
Board and Pin Assignments 17
2.4.13 Serial ATA Connectors (SATA1~SATA5)
These connectors (SATA1 and SATA2) support SATA 3.0 and are for the Serial ATA
signal cables for Serial ATA hard disk drives.
SATA1, SATA2
These connectors (SATA3, SATA4 and SATA5) support SATA 2.0 and are for the Serial
ATA signal cables for Serial ATA hard disk drives.
SATA3, SATA4, SATA5
Note
Connect the right-angle side of SATA signal cable to
SATA device. Or you may connect the right-angle
side of SATA cable to the onboard SATA port to
avoid mechanical conflict with large graphics cards.
2.4.14 USB Connectors (USB56, USB78, USB910 and USN1112)
These connectors are for USB 2.0 ports. Connect the optional USB module cable to any
of these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mbps connection speed.
1
Pin
Signal
1
GND
2
SATA_TXP2
3
SATA_TXN2
4
GND
5
SATA_RXN2
6
SATA_RXP2
7
GND
Pin
Signal
1
GND
2
SATA_TXP2
3
SATA_TXN2
4
GND
5
SATA_RXN2
6
SATA_RXP2
7
GND
Pin
Signal
Pin
Signal
1
USB+5V
2
USB+5V
3
USB-
4
USB-
5
USB+
6
USB+
7
GND
8
GND
9
NC
USB56, USB78,
USB910, USB1112