User manual

MANO870 Mini ITX Board
28 Hardware Installation
3.4.2 Configuring an Expansion Card
After installing the expansion card, configure it by adjusting the software settings.
1. Turn on the system and change the necessary BIOS settings, if any. See Chapter 5
for information on BIOS setup.
2. Assign an IRQ to the card if needed.
3. Install the software drivers for the expansion card.
3.4.3 PCI-Express x16 Slot
This motherboard supports one PCI-Express x16. The following figure shows a graphics
card installed on the PCI-Express x16 slot.
3.4.4 PCI-Express Mini Card Connector
This motherboard supports one PCI-Express Mini Card connector. The following figure
shows a Decode card installed on this connector.