User`s guide

AXIS 2110 User’s Manual Using Your Camera with a Modem
19
Connecting Your Computer Using the Null Modem Cable
Important!
Follow the steps below to configure a serial modem connection for your AXIS 2110:
• The information and screen examples shown in this section are from Windows NT. Although similar to the
Dial-up implementations in Windows 95, 98, and 2000, small differences in the dialog instructions for other
operating systems should be expected. Refer to your system information for further information on creating a
Dial-up modem connection if you are using any other operating system.
• Windows Dial-up Networking and TCP/IP must be correctly installed prior to commencing with the modem cable
connection. Detailed information on how to check this is provided in the Microsoft Windows Help.
❶ Connect the supplied Null Modem
Cable between the COM port on the
AXIS 2110 and the serial port on your
computer.
❸ From the Start menu, open the
Control Panel and double click the
Modems icon.
❼ Select the serial port to which
your AXIS 2110 is now connected
via the Null Modem cable. Click
Next>.
❽ A Standard 28800 modem
connection is now available for
the AXIS 2110. Click Finish to
close the Install New Modem
Wizard.
❹ If a Standard Modem is already set up and
displayed in the Modem Properties dialog (see
right) you should proceed directly to step 8.
❻ Select the Standard 28800
modem from the displayed list of
modems. Click Next>.
❾ Click the Properties button to finally check that the
displayed Communications Port is set correctly; that is, set
to the same port as you have connected the AXIS 2110.
Click OK.
❷ Connect the power supply to the
camera and check that the Power
Indicator is lit.
❿ Click Close.
❺ Check the box: Don’t detect my
modem, I will select it from a list.
Click Next>.