User manual

WHITE

AXMINSTER

Setting the Laser...



FREEPHONE 0800 371822

Warning. Under no circumstances should you tamper with or

modify the laser to try to increase its power output.

Dispose of spent batteries responsibly.

WARNING!!

THIS PRODUCT IS EQUIPPED WITH A

CLASS 2 LASER. DO NOT

LOOK

DIRECTLY INTO THE LASER BEAM

NOTE: The laser is individually powered. It does not switch on/off with the

application of Mains Power. REMEMBER to switch the Laser off when you have

finished using it to conserve the batteries.The laser marker fitted to the AWMS10

consists of two units; the Laser head and its mounting, and the battery pack. (See

Figs 11 & 12)

Fig 11 Fig 12

Laser Battery pack

Aligning the Laser

Find a piece of wide board with a flat straight edge. Using a square, mark a line at right

angles to the edge, extending across the width of the board. (See Fig 13) Offer the board

up to the rear fence of the Mitre Saw, lower the saw blade to the board and align the offside

or nearside of the teeth with the marked line. (See Fig 14) Clamp the board in this position.

Switch on the laser. Check the alignment of the laser with the line marked on the board.

(See Fig 15)

DISCONNECT THE SAW FROM THE MAINS SUPPLY

Square Pencil mark Pencil mark Laser line

Fig 13

Fig 14 Fig 15