User manual

WHITE
AXMINSTER
W
21
Table of Capacities...

FREEPHONE 0800 371822
With 250mm Diameter Blade fitted
Always use a 250mm Saw Blade with a rated speed in excess of 4,500 r.p.m. The machine is
supplied with a 250mm GP TCT (40 tooth) Saw blade, with a 16mm bore for cutting
TIMBER. For Precision trimming e.g. fine cut finish of bead, frame, dado etc., a 72/80 tooth
saw blade is recommended and for cutting non-ferrous metals, an 80 tooth negative rake
saw blade. It is also recommended that you use a lubricant when cutting aluminium. The
machine was designed to use only TCT blades. Do not use HSS 'plate' saw blades
WARNING!!
!
DO NOT CUT FERROUS METAL
Because of the geometry of the raising of the lower guard, the incidence of the saw at the
intersection of the fence and the table and the height of the saw washers above the table,
please study the available capacities that are shown below, and the accompanying
notations.
The table is drafted with the first measurement being the dimension against the fence.
(Height) These measurements indicate the size of the timber that can be cut by the machine
with minimum interference with the 'self' operation of the guard, for slightly larger sizes it
may need to be hand manoeuvred to operate correctly.
Although the saw is capable, with the correct saw blades fitted, of cutting plastic,
aluminium, P.V.C., etc, the cutting table deals exclusively with timber.
Timber Size Mitre Angle Tilt Angle
67 x 140 0 0
67 x 95 45 0
40 x 140 0 L45
40 x 95 45 L45
We do not recommend that any sawing operations are carried out without the work being
securely clamped to the machine.