Installation Instructions / Warranty 90564101 06/2005 Starck 10444XX1 10454XX1
Starck 4-Hole Roman Tub Trim 10444XX1 10454XX1 10444XX1 10454XX1 Installation Considerations • • This trim kit must be used with rough-in 13444-181. The handshower must be used. Backflow protection is provided by a check valve in the handshower connection hose. Additionally, the diverter will automatically spring back to the "spout" position if a backflow condition exists.
Replacement Parts 9 4 1 8 7 3 14x2,5 2 23x2,5 22x2 6 10 12 9x2,5 5 11 11x2 1 2 3 4 5 6 7 8 9 10 11 12 diverter knob aerator cpl. spout cpl. 10444XX1 spout cpl.
1 Installation Instructions Remove the plaster guards (1) from the valve corners and the spout adapter. • Install the glide rings (2) • Install the handles (3) by pressing firmly over the handle snap connectors. • Turn the handles clockwise to make sure that the valves are in the "off" position. CAUTION: Do not install the handles unless the snap connectors are screwed firmly to the stems. • 2 • Remove the plug from the spout adapter using a 27 mm wrench.
4 • Remove the diverter knob from the spout (1). Use a small screwdriver to push the screw and screw cover from the diverter knob (2). 5 • Install the spout (1) to the spout adapter over the diverter. Tighten the set screw (2) with the enclosed 3 mm allen wrench. 6 • Install the diverter knob (1) and screw (2), using a small screwdriver (not included). The screw will engage the female fitting on the diverter stem. Install the gray screw cover (3).
7 • Pull the outer SecuflexTM hose through the handshower mount. 8 • Lubricate the handshowr mount and outer SecuflexTM hose with spray silicon lubricant or with a tablespoon or so of water. 9 • Pull the outer SecuflexTM hose completely from the handshower mount. Unscrew the outer SecuflexTM hose (1) from the handshower connector hose (2). Do not allow the handshower connector hose to fall back through the hole! Remove the brass plug (3) from the handshower connector hose (2).
10 • Use the enclosed cleaning towelette to thoroughly clean the outer SecuflexTM hose. 11 • Feed the inner SecuflexTM hose through the outer SecuflexTM hose (1) • Attach the inner SecuflexTM hose to the handshower connector hose (2). • Remove the plaster guard from the outer SecuflexTM hose (3). • Remove the end cap and the liner from the handshower holder.
13 14 15 8 • Feed the inner hose through the handshower holder (1), liner (2), and end cap (3). • Screw the end cap (4) over the end of the handshower holder. • Continue pulling "out" on the inner hose (5). • Place the handshower holder retainer ring (1) over the hose and the handshower holder. • Install the screen washer and the handshower on the hose (2). • Use a knife to cut the o-rings at the end of the outer hose. • Feed the hoses back through the handshower mount.
• 16 Secure the handshower holder to the handshower mount with the retainer ring. User Instructions • Turn the left handle for hot water, the right handle for cold. • Pull up on the diverter knob to divert the water to the handshower. The diverter will automatically reset to the tub spout when the water is turned off. • The handshower uses the Rubit!TM self cleaning system. The spray channels are lined with a material that resists scale deposits.
Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • • • • To remove lime scale, use only products made specifically for that purpose.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. C.
Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta GA 30004 Tel 770 360-9880 • Fax 770 360-9887 www.hansgrohe-USA.