Installation Guide

Page 2
STORAGE & HANDLING
• Store AZEK Trim and Moulding products on a flat and level surface.
• Since AZEK Trim and Moulding products are more flexible than wood, they may conform to uneven
surfaces. Ensure that storage areas, as well as all framing and substructures, are flat and level to
minimize uneven surfaces.
• AZEK Trim and Moulding products have a density comparable to pine and should be handled in a
fashion as pine would be handled to avoid damage.
• Units of AZEK Trim and Moulding products are shipped from the manufacturer in a protective
covering. If covering has been removed, take care to keep product free of dirt and debris at jobsite.
If product gets dirty, clean after installation.
• Care should be taken in handling the individually wrapped column
wraps to prevent tearing of tape or cracking at miter lock corner joints.
CUTTING
• AZEK Trim and Moulding products can be cut using the same tools used to cut
lumber.
• Carbide tipped blades designed to cut wood work well. Avoid using fine tooth
metal cutting blades.
• Rough edges from cutting may be caused by excessive friction, poor board
support, or worn or improper tooling.
DRILLING
• AZEK Trim and Moulding products can be drilled using the same tools used to drill
lumber.
• Drilling AZEK Trim and Moulding products is similar to drilling a hardwood. Care
should be taken to avoid frictional heat build-up.
• Periodic removal of AZEK shavings from the drill hole may be necessary.
• AZEK Trim and Moulding products can be routed using standard router bits and
the same tools used to rout lumber.
• Carbide tipped router bits are recommended.
• Routing AZEK Trim and Moulding products provides a crisp, clean edge.
ROUTING
Installation Guidelines for AZEK
®
Trim and Moulding