Owner manual

Programming
The computer board is located inside the
control module. In the middle of the board is a
small toggle switch used to change from Run
mode to Program mode (see illustration).
WARNING!
Dangerous voltages can be
present inside the control
module. Only qualified
service technicians with
specific knowledge of test
procedures and safety precautions should
attempt troubleshooting and repair. Disconnect
power before removing panels and covers, and
before attempting service procedures.
The Run/Program switch is normally in the Run
mode position. To enter program mode, flip
the switch to the opposite position (Program
mode). The display changes to show the
current temperature in the wash cylinder,
indicating that the control is in program mode.
See the next section for key functions while in
program mode.
Key Functions in Program Mode
The Up key is used to increase
cycle numbers and other
numerical values, like time and
temperature, when creating wash
formulae.
The Down key is used to
decrease cycle numbers and
other numerical values, like time
and temperature, when creating
wash formulae.
The Stop key saves all data and
terminates the programming
procedure. If you press this key
first when entering program
mode, the computer will enter
Setup. If the stop key is pressed
again, you will exit
Setup mode and return to
Program mode.
The Start key is the Enter
command while in Program
mode. Pressing this key enters
the data, and moves to the next
programming function in the
cycle.
10
J1
FLIP SWITCH
FOR PROGRAM
MODE, NEWER
MODELS USE
PASSWORD -
SEE BELOW.
J6
R16
Version b263 does not have the program switch
but instead uses a password (1234) to access
program mode. The control shows the
firmware version at power on.
BPress the Up and Down keys together. The
display shows .0
BPress the Up key once. The display shows .1
BPress the Start key. The display shows .10
BPress the up key twice. The display shows
12.
BPress the Start key. The display shows .120
BPress the Up key three times. The display
shows .123
BPress the Start key. The display shows .1230
BPress the Up key four times. The display
shows .1234
BPress the start key. The display will show the
temperature, indicating that the control is
now in program mode.
Cycle power to save the program changes after
programming is complete.