Owner manual

ManualsBrandsB&C Technologies ManualsControl panelA-Computer Programming(HE Series)

Programming

Cycle Programming (continued)

After selecting your desired supply option, press

the Start key.

If your machine is equipped with Auxiliary

heating, and it was enabled during Setup

programming, you may use the up or down key

to select the target temperature for the segment.

To disable Auxiliary heat for the segment, set

the value to zero.

NOTE

If the machine does not have auxiliary

heating, do not program a temperature.

If you program a target temperature that

the machine is unable to achieve, the

machine will try for 30 minutes during

the segment. It is also important not to

program heat during a prewash segment

with a flush fill.

After you have selected the temperature, press

the Start key.

Now select the spin time for the segment. If

you wish to skip the spin, set the value to zero.

NOTE

If the machine does not have auxiliary

heating, do not program a temperature.

If you program a target temperature that

the machine is unable to achieve, the

machine will try for 30 minutes during

the segment. It is also important not to

program heat during a prewash segment

with a flush fill.

Details

Use Up or Down to change. Start key is enter or advance

PRE or FLUS Select Regular prewash or Flush

00 or 02 - 30 Segment time: 00 to skip, or any time between 0 and 30 minutes

HFIL CFIL BFIL Fill temperature: Hot, Cold, or Warm (both fill)

SUP0 - SUP7 Select Supply 0-7 (0 for no supply during the step)

00, 75 - 200

00, 25 - 93

SPIN flases for 1 sec

TIME flases for 1 sec

00 or 30 - 120

Select time for spin: 30 - 120 seconds. 00 for no spin.

Note: Supply 4 and 7 are only availble if enabled in Setup

Note: Heat is only available if enabled in Setup

Prewash Segment

Display

PRE

Enter temperature: 75-200 deg F, 25-93 deg C. 00 for no heat.

Select 00 if you have programmed a Flushing Prewash

Cycle Segment Charts

After you have set the spin time, press the Start

key, The display will now show the name of

the next program segment. See the chart on

page 10 for the list of program segments and

what the display indicates for each.