Owner manual

Introduction
LED Display
Cycle
Up
Cycle
Down
Stop
Start
A-computer
The A-computer is a powerful and versatile
solid state control. Up to 30 programs can be
stored and executed. The computer comes
standard with several pre-programmed cycles,
which are discussed later in the manual (see
table of contents for locations).
Note: Do not power off the machine while the
mode switch is in Program position. Doing this
will result in program data corruption, requiring
a reprogramming of some or all of the cycles.
Always move the Program switch into the Run
position before powering down the equipment.
Keypad
The user interface for the A-computer control is
a four pushbutton keypad with an LED (Light
Emitting Diode) display. This interface is
located on the front of the machine. In Run
mode, the keys function as follows:
Used in cycle selection:
Customer Service
For technical assistance, call the following
number:
In the United States
Phone: [phone]
FAX: [phone]
e-mail: [e-mail]
Web: www.bandctech.com
In Thailand
Phone: [phone]
FAX: [phone]
e-mail: [e-mail]
Web: www.accuratethai.com
Replacement Parts
In the event that literature or replacement parts
are required, contact the local distributor of the
equipment, or contact B&C Technologies at the
above phone numbers/internet addresses.
3
Pressing this key increments
the cycle up by one; during a
cycle, shows the temperature.
Pressing with the down arrow
advances the program (if
enabled, see page 11).
Pressing this key increments
the cycle down by one; during a
cycle, shows the temperature.
Used to stop a cycle in progress
Used to start a cycle; during a
cycle, displays the current
cycle.
cY01