User Manual

98
MATLAB
®
The oscilloscope saves the waveform data to external memory in *.DAT format, an ASCII plain-
text format. You can further analyze the data using MATLAB® or other software. Recalling the
DAT file is not supported. MATLAB® is a registered trademark of The MathWorks, Inc.
10.2 Setup Internal Save and Recall
Save setup to internal memory
1. Press the Save/Recall button to enter the SAVE/RECALL menu.
2. Press the Save softkey to enter the SAVE menu.
3. Press the Type softkey and turn the Universal Knob to select Setups. Press the knob to
confirm.
4. Press the Save To softkey to select Internal to save the current setup of the oscilloscope
to internal memory.
5. Press the Setup softkey button and turn the Universal Knob to select the memory
location to save to. There are 20 internal locations that can be saved to.
6. Press the Save softkey to save the current setup to the selected location. After a few
seconds, a message will be displayed saying the operation was successful.
Load setup from internal memory
1. Press the Save/Recall button to enter the SAVE/RECALL menu.
2. Press the Recall softkey to enter the RECALL menu.
3. Press the Type softkey and turn the Universal Knob to select Setups. Press the knob to
confirm.
4. Press the Recall From softkey and turn the Universal Knob to select Internal. Press the
knob to confirm.
5. Press the Setup softkey and turn the Universal Knob to select the location that you want
to recall.
6. Press the Press To Recall softkey to recall the setup. After a few seconds, a message will
be displayed saying the operation was successful.
10.3 External save and recall
Before using external storage save and recall, make sure a USB storage device is connected. All
file types are available for external save. Only setups and references are available for external
recall.
External Save
1. Press the Save/Recall button to enter the SAVE/RECALL menu.
Note: To delete a setup file in memory, save a new setup to the same location to overwrite it.