User Manual

107
3. Press the I/O Set softkey to enter the I/O SET menu.
4. Press the LAN softkey to enter the LAN configuration interface:
Press the left-most softkey (the first softkey below the screen; the firmware calls it F1) continually
to go to the DHCP line; then turn the Universal Knob to select Enable or Disable.
 Enable: the DHCP server in the current network will assign the network parameters (such
as the IP address) for the oscilloscope. The other settings are inactive.
 Disable: you can manually set the IP address, subnet mask, and gateway address
manually.
 Turn the Universal Knob to select the desired value.
 Push the Universal Knob to set the displayed value and move right to the next value.
 Press the F1 softkey to go to the next line.
 Press the Save/Recall softkey to save the current settings.
 Press the Single button to exit the setting interface.
5. Use the operation software or NI Visa to communicate with the oscilloscope over the LAN.
Figure 97 - LAN configuration interface