User Manual

138
• If the D0~D7 softkey is set to Custom, press the Custom softkey and turn the Universal
Knob to select the desired value (-3 V to 3 V) and push the knob to confirm.
16.7 Repositioning a Digital Channel
1. Press the Digital button on the front panel to open the DIGITAL function menu and display
the digital channel waveforms.
Figure 131 - Reposition digital channel
2. Press the fourth softkey to select Activated Channel and push the Universal Knob to confirm.
Turn the Universal Knob to select the channel to reposition. The selected waveform is
highlighted in red.
3. Press the fourth softkey to select Position and push the Universal Knob to confirm. Turn the
Universal Knob to move the selected channel to current position.
16.8 Displaying Digital Channels as a Bus
Digital channels may be grouped and displayed as an 8-bit bus, with each value displayed at the
bottom of the display in hex or binary. You can have one or two buses.
To configure and display each bus, follow these steps:
1. Press the Digital button to open the DIGITAL menu and display the digital channel waveforms.
2. Press the Digital Bus softkey to enter the DIGITALBUS menu.