User Manual

52
3. Press the Source softkey. Turn the Universal Knob to select the analog channel you wish to
use as the trigger source.
4. Press the Slope softkey to choose between rising and falling slope. The current trigger slope
is displayed at the upper right corner of the screen.
Figure 51 - Slope trigger
5. Press the Limit Range softkey.
6. Press the softkey to the immediate right of the Limit Range softkey to adjust the slope time(s).
7. Turn the Universal Knob to select the desired slope condition and push the knob to confirm.
 < (Less than a time value): Trigger when the slope time of the input signal is less than the
specified time.
 > (Greater than a time value): Trigger when the slope time of the input signal is greater
than the specified time value.
 [--,--] (Within a range of time values): Trigger when the slope time of the input signal is
greater than the specified lower limit and less than the specified upper limit.
 --][-- (Outside a range of time values): Trigger when the slope time of the input signal is
greater than the specified upper limit or less than the specified lower limit.
8. Press the Next Page softkey and press Lower Upper softkey to set the Lower and Upper
trigger levels.
9. Turn the Trigger Level knob to adjust the position. The trigger level values are displayed at
the upper right corner of the screen.