User's Manual

Main functions of Radenso HD+
Radenso HD+ equipment is the first radar detector from the Radenso family, intended for fixed
installation in vehicles. It is designed to protect the driver from fines for speeding; its main
functions are detections of micro-wave radars (X / K / Ka narrow bands) and laser guns. In
combination with GPS detector Radenso GPS+ (wireless connection), it communicates with drivers
in English language and also detects GPS points like red light cameras and sectional speed
cameras.
Installation:
Installation of Radenso HD+ is not complicated; however, it is recommended that the installation is
committed to a professional service or your retailer if it is capable of ensuring an appropriate
quality technical support.
Installation of the radar antenna:
The antenna captures signals emitted by radars; the choice of the installation place is therefore
crucial to its proper functioning and good sensitivity of the detector.
The antenna is mounted to the front of the car, usually into its plastic bumper or behind the front
grille in front of the vehicle radiator. It must be installed in the place from where the front part has
a good view of the road ahead. It is ideal to locate the antenna into the bumper vent, 30-50 cm
above the ground. If you choose to mount the antenna so that the bumper covers its front part,
check the material from which the bumper is made and whether it contains a metal
reinforcement. Some types of plastic can weaken radar waves and reduce the efficiency of the
detector. Never mount the antenna behind metal parts of the vehicle!
In North America, install the antenna in a horizontal position for maximum performance. Only in
countries that use horizontally polarized radar gun a vertical installation is recommended. The
connecting cable must point backwards and mounting holes up and down.
Selection of mounting screws:
When installing the antenna, you can use self-tapping screws in places where the nut can be
attached from the other side, as well as classic nut bolts:
Screw
Antenna Self-tapping screw
Mounting area Spring part
Hole 5mm Support plate
Support plate Antenna
Spring part Hole 3.7 mm
Nut Mounting area