User's Manual

Mounting the antenna:
After selecting a suitable location for the antenna and the type of screws, drill two to four screw
holes. It is recommended that the antenna is attached with 4 screws. The antenna cable can be
slightly bent. Firstly, attach the antenna with two screws crosswise against each other and tighten
them partly; then mount the remaining two screws.
In some vehicles, it is advisable to carry out the installation using a special support plate that is
included in the sales package. It has the shape of the letter “L” and is made of thick steel plate
with pre-drilled holes. Firstly, screw the support plate to the appropriate place, and then attach
the antenna to the plate.
An example of the antenna vertical installation (the arrow points in the driving direction > front of the
car):
Remember: A vertical installation is only recommended in countries where horizontally polarized
radar guns are in use (e.g. Australia)
An example of the antenna horizontal installation (the arrow points in the driving direction > front
of the car):