Instruction manual

-9-
FOOT CONTROL
Use of foot control will permit control of start, stop and speed with your foot.
CAUTION: To prevent accidents.
1.Turn the power switch.
2.Push foot control plug into receptacle on machine.
3.Place foot control at your feet and turn power switch.
Sew faster by increasing the pressure on the foot control.
To stop, remove your foot from the foot control.
CONTROL BUTTON FUNCTIONS
Some control button functions described in
previous page will change when the foot
control is connected.
A.START/STOP BUTTON
This button will be deactivated.
B.SLIDE SPEED CONTROL LEVER
This button is not operable when foot control is used.
C.REVERSE STITCH BUTTON
When using stitches 1,2, and 6,the machine will continue to sew reverse at slow speed while
this button is pressed. When released, the machine will sew forward.
WARNING:
-To reduce the risk of burns, fire, electric shock, or injury to persons.
1.Handle the foot control with care and avoid dropping it on the floor. Be sure not
to place anything on top of it.
2.Use only foot control provided with this machine.
B
C
A
O
N
O
F
F
OFF
ON
When sewing other stitches, the reverse stitch button is used as tie-off.
SAFETY FEATURE OF ELECTRONIC MODEL
If the machine is jammed, it will stop with three
beep sounds. After the cause of jamming is
removed, step on the foot control and it will
run in normal condition.