Extra Information

IQ DESIGNER WITH SCAN
18
Using the Scan Frame
a
Prepare the desired drawing/illustration.
b
Place the paper to be scanned in the
scanning frame, and then secure the paper
in place with the magnets.
* Place the magnets at six locations around the paper
to secure it, making sure that the line drawing is not
covered.
IQ DESIGNER WITH SCAN
CAUTION
• Do not set the fabric, the paper with crease or
luster or the paper that is too thick or rolled up
to the scan frame. Otherwise, the frame may
strike the embroidery foot, and possibly cause
injury.
Memo
• Only one sheet of paper can be placed in
the scanning frame per scan.
Note
• When placing the paper in the scanning
frame, make sure that the white balance
area is not hidden; otherwise, the drawing
cannot be scanned correctly. At the same
time, be sure to place the scan image within
the scan area. The image out of the scan
area will not be scanned.
a White balance area
b Scan area
• Make sure that the white balance area or
the scan area is not dirty or scratched;
otherwise, the image cannot be scanned
correctly.
• Be sure to use the magnets which are
included with the scanning frame. If any
other magnets are used, they may become
attached to the machine during scanning, or
other problems, such as a misaligned scan
image, may occur.
• Be sure to place the magnets so that they
secure the paper firmly. If the paper is
placed unevenly, the image cannot be
scanned correctly.
• If the scanning frame is dirty, wipe it with a
cloth dampened with a diluted neutral
detergent solution.
Memo
• If you want to scan an image from a small
piece of paper that can't be held with the
magnets, copy that image onto a larger
piece of paper, to then be placed on the
scanning frame.