Operation Manual

USING SENSOR FUNCTIONS WITH SEWING STITCH
Sewing Basics
103
2
Using the Sensor Pen to Specify
the Sewing End Point
Before start sewing, test the pattern first from steps
a to c to see if the stitch can be used with this
function. Before starting to sew, mark the end
point.
a
Start sewing after a stitch has been selected,
and then stop the machine when the
desired sewing end point enters the sensor
pen touch range.
b
Press .
→ The sensor functions screen appears.
c
Press .
→ The sewing end point setting screen appears.
Note
• In order to specify the end point of a longer
piece of fabric more accurately, use the
sensor pen to touch the end point twice. Be
sure to touch the same point.
• Before starting to sew, mark the end point
of this longer piece of fabric.
Note
• If the needle drop point is being specified
with the sensor pen within 70 mm (approx.
2-3/4 inches) from the sewing end point, the
machine will not require the second touch.
After completing step
d, continue with
step
h. However, the actual sewing end
point may be slightly different than the
specified location.
In order to specify the location accurately,
stop the machine at a location more than
70 mm (approx. 2-3/4 inches) away from
the sewing end point before specifying it for
the first time.
Memo
• If the needle drop point is greater than
100 mm (approx. 4 inches) from the
selected ending point using the sensor pen,
a more accurate position can be specified
the second time that the point is touched.
Note
• If is not available, the sewing end
point cannot be specified with the selected
stitch pattern. Select a different stitch
pattern.