Instruction manual

8
5
7
4
6
9
2
1
3
3
2
20
While holding thread with finger, pass it between the tension
discs and pull thread down to make certain it is properly
located in between the tension discs.
3
Thread the top cover
thread guide by pulling
the thread towards the
left until it slips under
guide. Then pull thread
along the right side of
pretension disc as
illustrated.
Pass thread from back to the front through thread guide.
1
2
4
5
6
7
8
Slip thread behind metal guide and into rear slot on thread
guide.
Pass thread into the slot of take-up lever cover.
Position thread into the right guide located at base of take-up
lever cover.
Slip thread from left to right into the thread guide located
on bottom of the needle clamp. Position the thread into the
right section of the guide.
Note: Before threading eye of needle, slip thread behind thread
guide located on the bottom of the needle clamp.