Instruction manual

24
Note: Slide thread into rear slot on thread guide 5 and slot of
take-up lever cover 6. Then slip thread into left slots of
thread guides 7 and 8.
Before threading eye of needle, make sure thread is in front of
thread guide located on the bottom of the needle clamp, for
cover stitch and for chain stitch.
(2) Threading the
(Yellow) (D on needle clamp)(center needle)
Cover Stitch Middle / Chain Stitch Needle
10cm
(4")
9
8
7
5
5
8
9
4
7
3
6
2
1
6
4
9
Thread the eye of the left needle.
Note: Use of tweezers in the accessory case will make needle
threading easy.
Draw about 10cm (4 inches) of thread through needle eye
to hang free.
Place the thread to the back, and slightly to left under the
presser foot.
9
Thread the center needle as indicated in steps 1 through 9.
- Raise presser foot to release tension discs.
4
5
6
7
8
Slip thread behind metal guide and into rear slot on thread
guide.
Pass thread into the slot of take-up lever cover.
Position thread in the left guide located at base of
take-up lever cover.
Slip thread from left to right into the thread guide located
on bottom of the needle clamp. Position the thread into the
left section of the guide.