Instruction manual

27
Note: Before threading eye of needle, make sure thread is in
front of thread guide located on the bottom of the needle
clamp for cover stitch.
3
10cm
(4")
9
8
5
7
4
9
3
6
While holding thread with finger, pass it between the tension
discs and pull thread down to make certain it is properly
located in between the tension discs.
3
Thread the eye of the right needle.
Note: Use of tweezers in the accessory case will make needle
threading easy.
Draw about 10cm (4 inches) of thread through needle eye to
hang free.
Place the thread to the back, and slightly to left under the
presser foot.
9
4
5
6
7
8
Slip thread behind metal guide and into front slot on thread
guide.
Pass thread into the slot of take-up lever cover.
Position thread into right guide located at base of take-up
lever cover.
Slip thread from left to right into the thread guide located
on bottom of the needle clamp. Position the thread into the
right section of the guide.