Instruction manual
28
To easily change thread type or color, clip thread near the spool,
and remove old spool of thread.
.
Place new thread on stand.
square knot.
Clip thread tails to 2~3cm (1 inch) length. If clipped too short,
threads may come untied.
Firmly pull both threads to test knot security.
Tie new thread and old thread ends together with a
Pull the threads through the machine one at a time.
If threads do not pull easily, check for tangles on thread guides or
looping under thread stand.
When pulling thread through the needles, when the knot is in
front of the needle.
STOP
Cut the thread, and insert, in the eye of the needle.
14. EASY THREAD :CHANGE TIE ON METHOD
-Raise presser foot to release tension discs.