Operation Manual

BEFORE EMBROIDERING
128
BEFORE EMBROIDERING
Embroidery Step by Step
Follow the steps below to prepare the machine for embroidery.
Step # Aim Action Page
1 Presser foot attachment Attach embroidery foot “W”. 129
2 Checking the needle* Use needle 75/11 for embroidery. * 38
3 Embroidery unit attachment Attach the embroidery unit. 130
4 Bobbin thread setup** For the bobbin thread, wind embroidery bobbin thread and set it in place. 21
5 Fabric preparation Attach a stabilizer material to the fabric, and hoop it in the embroidery frame. 140
6 Pattern selection Turn the main power to ON, and select an embroidery pattern. 132
7 Embroidery frame attachment Attach the embroidery frame to the embroidery unit. 145
8 Checking the layout Check and adjust the size and position of the embroidery. 146
9 Embroidery thread setup Set up embroidery thread according to the pattern. 27
* It is recommended that a 90/14 needle should be used when embroidering on heavy weight fabrics or stabilizing products (for example;
denim, puffy foam, etc.).
** Use the alternate bobbin case for any embroidery bobbin thread other than the recommended embroidery bobbin thread (item BBT-W,
page 6).
Step 3
Step 1, 2
Step 7
Step 5
Step 4
Step 6, 8
Step 9