Operation Manual

SEWING THE STITCHES
Utility Stitches
77
3
d
Position the side cutter so that the side
cutter pin is aligned with the notch in the
presser foot holder, and then lower the
presser foot.
a Notch in presser foot holder
b Pin
→ The side cutter is attached.
e
Make a cut of approximately 20 mm
(approx. 3/4 inch) in the fabric.
a 20 mm (approx. 3/4 inch)
f
Position the fabric so that the right side of
the cut is on top of the guide plate and the
left side of the cut is underneath the presser
foot.
a Guide plate (lower knife)
b Presser foot
g
Thread the needle manually and pull out a
long section of the upper thread. Pass it
below the presser foot and pull it out in the
fabric feed direction.
a Presser foot
b Upper thread
h
Start sewing.
→ A seam allowance is cut while the stitching is sewn.
Memo
If the fabric is not positioned correctly, the
fabric will not be cut.
a
b
a
a
b
Note
If the width has been adjusted, turn the
handwheel by hand to check that the needle
does not touch the side cutter. If the needle
touches the side cutter, it might cause the
needle to break.
b
a