Extra Information
43
■ If the Image Data Cannot Be Saved
If the screen shown at the left appears, the image data
cannot be saved because either the USB media is
full or the embroidery data being saved is larger than
the amount of space available. To be able to save the
image data on the USB media, previously saved image
data must be deleted.
* To replace the USB media or quit saving, press .
Image data is deleted in the same way that embroidery
data is deleted. For details, refer to page 38.
* Data cannot be saved on the USB media in the following
cases.
• WhensavingontoUSBmediacontainingdataotherthan
image data, such as embroidery data, and a list of image
data does not appear even when
is pressed.
• WhensavingontoUSBmediacontainingdataotherthan
image data, such as embroidery data, and the new image
data is not saved even when other image data is deleted.
Press , and then change the USB media.
Recalling Image Data
1 Insert USB media containing image data into the
available USB port located on right side of machine.
2 Press in the pattern drawing screen.
* The key is not available when the pattern is displayed
in the enlarged area. Press the
key to close the
enlarged area.
3 The following message appears.
Caution
Do not turn off the machine while this message is displayed,
otherwise saved data may be lost. In addition, do not try to
remove the USB media while recalling data, otherwise the
USB media may be damaged.