User Guide
Table Of Contents
- Section 1. Introduction
- 1.1. How to Use This Manual
- 1.2. Warning Statements
- 1.3. Caution Statements
- 1.4. Hazard Symbols Located on the Monitor
- 1.5. Safety Precautions
- 1.5.1. AC Power Supply
- 1.5.2. Protective Grounding
- 1.5.3. Explosive Atmosphere
- 1.5.4. Proper Exhaust Venting
- 1.5.5. Accessing the Interior of the Monitor
- 1.5.6. Misuse and Modifications to the Monitor
- 1.5.7. In Case of Malfunction
- 1.5.8. Fusing
- 1.5.9. Installation Category
- 1.5.10. Altitude Limit
- 1.5.11. Cleaning
- 1.6. Functional Overview
- 1.7. Specifications
- Section 2. Installation
- Section 3. Operation
- Section 4. Maintenance
- 4.1. Warnings and Cautions
- 4.2. Charcoal Filter (Halogen Gas Monitor Only)
- 4.3. Hydrophobic Filters
- 4.4. Servicing Air Lines and Termination Filters
- 4.5. End-of-Line Water Stop (Optional)
- 4.6. Water Trap (Optional)
- 4.7. Fuses
- 4.8. Clock Battery
- 4.9. Sample Pump
- 4.10. Replacement Parts and Optional Accessories
- 4.11. Service Centers
- Appendix A. Data Tables
Single Zone Gas Monitor
10 P/N: 3015-4256 Rev 10
2.4. Interior Schematic (Halogen HGM)
Figure 2-4. Interior Assembly of the Single Zone Halogen Gas Monitor
NOTE: The plastic cable tie surrounding the pump is for stability during shipping. Please
remove before operating. If the unit gets shipped to Bacharach for service, reinstall a
plastic cable tie around the pump to prevent damage during shipping.
**For IR Bench Gas In/Out, see SZ bottom view drawing on page 7.