Specifications

Halogen Gas Monitor – MultiZone Remote Display
Instruction 3015-5157 29
4 General Operation
Functional Overview
Normally each HGM-MZ will sequentially perform measurements on its active zones without user input. The
total time it takes an HGM-MZ to complete a measurement cycle is directly proportional to the number of
active zones and the physical length of the air lines. Monitors linked together on a network operate
independently of each other and consequently complete their respective measurement cycles at different
rates.
The HGM-RD operates by polling the network approximately once every 12 seconds to determine the current
status of the HGM-MZ monitors. If more than one HGM-MZ is connected to the network, it will sequentially
poll each monitor for its status. This means that the more complicated the network, the longer it will take the
HGM-RD to update the status information for all zones.
To display all the zones being monitored, go to the System Screen (Page 19) and press the ZONES key.
The Zone Screen
The top level Zone Screen provides a summary view of zone activity across the network. Each screen
displays information from a single HGM-MZ monitor as indicated at the top of the display. Each screen can
display information for up to 8 zones, and depending on the configuration of the system, there can be up to
two screens for each HGM-MZ. Use the UP/DOWN cursor keys or the NEXT key to scroll the screen display.
Each box displays the zone location and the last PPM measurement. A blinking box indicates that a
measurement is currently being taken in that location. An inverse flashing box indicates an alarm condition in
that zone.
Use the LEFT/RIGHT cursor keys to scroll through the zones.
Zone Screen
To further investigate the status of any zone, select the zone and press the ENTER key. That monitor's Zone
Setup Screen #1 will be displayed.