Instruction manual

PARTS AND ACCESSORIES
Figure 2
BEFORE USING FOR THE FIRST TIME
1. Carefully unpack the Popcorn Maker and remove all packaging materials.
2. Place the main unit on a clean, flat, working surface.
CAUTION: After preheating, the stainless steel kettle gets hot. Use caution
when adding oil and popcorn to the hot stainless steel kettle.
CAUTION: Always wait until all popping ceases before opening the front door.
3. Clean the floor and the inside of the main unit with a moist, non-abrasive sponge or
cloth. Wipe with a clean cloth and dry thoroughly.
4. Flip both of the kettle lids up and wipe the inside. Open the front door.
5. Attach the kettle to the motor. With the embossed CAUTION (replace with triangle
symbol) facing forward and the motor cord receptacle facing the back, tilt the kettle
towards you and slide both side arms of the kettle straight back into the brackets. It
may be necessary to grasp the bracket and fit it to the track on the side arm. When the
side arms are correctly seated into the brackets, flip the kettle up and the geared top of
the rotating rod will fit into the front. Inspect the top gear and then both brackets to
ensure the kettle side arms and rotating rod are properly locked into position（Fig.1）.
CAUTION: Do not remove the kettle while it is in use.
Do not touch any hot surface until the kettle is fully cooled.
6. Attach the power cord into the kettle’s motor receptacle located at the bottom rear of
the kettle unit(Fig.1).
7. Attach the crank, fit the threaded stem of the crankshaft through the hole in the side of
the main unit/popcorn chamber. (See Fig.2) Turn the crank counter-clockwise to
attach. Hold the kettle with the other hand and tighten until the crank is securely
attached to the stainless steel kettle.
8. The Popcorn Maker is now ready for use.
5