User's Manual

GALAXY® II Gateway Receiver
Tools and Materials (customer-supplied)
• Precision slotted screwdriver 2.4 mm (0.094 inch) blade size
• Two 9/16 inch or adjustable wrenches for mounting V-block clamps (standard mounting)
• Band-IT® tool (refer to page 11) and instructions, a 1/2 inch wrench and a hammer for large diameter
pole mounting
• Wrench for 1-1/16 inch gland nut and 1-1/16 inch dome nut
• Strap wrench for backhaul antenna
Using the V-block Clamps
The V-block mounting equipment is sized to mount the gateway on a vertical or horizontal pole with outer diameters ranging
from 1-1/4…2-1/2 inches. For mounting on poles larger than 2-1/2 inches, refer to "Banding Mounting" on page 12.
1. Open the bag of mounting equipment.
2. Place two bolts (3/8-16 x 5 inches) through the holes in the top of the gateway mounting backplate (Figure 5).
Use the side holes for horizontal installation.
3. Place a clamp onto the bolts, as shown below.
4. Place a lock washer and nut onto each bolt, as shown below.
OTE:N The lock washer and nut nearest the enclosure mounting bracket may be omitted when mounting on smaller
diameter poles to provide additional clamping distance.
Figure 5: Attach hardware
5. Tighten the two nuts with a 9/16-inch or adjustable wrench, so that each lock washer is fully compressed and at.
6. Repeat Steps 2 through 5, attaching a clamp to the bottom of the mounting backplate. Position the gateway on the
pole and place a clamp on the top bolts.
need new picture
need new picture
Page 10 February 2014