User's Manual

Installation Manual
Figure 6: Receiver positioning and clamps
7. Place a lock washer and nut on each bolt and tighten the nuts 100…150 inch-pounds to ensure the gateway is
suciently secured to the pole.
8. Repeat Steps 6 and 7 for attaching the V-block clamp mounting bracket hardware to the bottom bolts of the gateway
mounting backplate.
Side View Back Side View
Figure 7: Completed gateway mounting (GPRS unit shown)
Bolts
Clamps
Nuts
Lock
Washers
Lock
Washer
need new picture need new picture
Page 11 February 2014