User's Manual

Installation Manual
Figure 13: Stripped cable wires
3. Shorten the foil shield ush with the outer jacket.
4. Strip the ends of the six (6) colored wires to a length of 1/8 inch. Twist the conductors on each wire.
5. Shorten the drain/bare wire (no insulation) to 11/16 inch.
6. Loosen each screw (about 2…3 turns) on the female insert and attach the wires to the insert using the chart below.
Retighten each screw after the wire has been connected.
Function Wire Female insert connector
Female Insert Diagram - Top View
Female Insert Photo - Top View
RS232 White 4
V DC– Drain 8 (center)
V DC– Black 3
V DC+ Blue 7
V DC+ Red 1
RS232 Green 5
V DC– Brown 2
Not used Not
used
6
* Used with the serial programming harness ( 66529-002)
**For use with shielded cable only
7. Assemble the insert by aligning the female insert tab slot with the notch in the coupling sleeve.
Figure 14: Slot alignment
Insert Tab Slot
Coupling Sleeve
Insert Notch
Slot
Brown
Red
Black
Blue
White
Not
Used
Green
Drain
Page 15 February 2014